RCA RCU1010 User Manual

11
With the RCU1010, you have the ability to customize the LCD key labels to meet your needs. Key
Label Options allow you to change the LCD key labels to match the functions on your original
component remote controls. It is recommended that the Key Label Options feature be used only after
you have finished programming all your components. This feature allows you to select from multiple
preset key labels to be shown on the touchscreen. You can change any LCD panel key except the LCD
LEARN and MACRO keys. Any one of the available preset key label options can be chosen for each
key. You can also choose to show only the key frame or hide the key completely.
Change LCD Component Key Labels
You can change the name of your component keys, if desired (VCR, SAT, etc.).
The TV component key label cannot be changed.
To choose from the preset key label options for LCD component keys, follow these steps:
1. Press and hold the SETUP key on the rubber keypad for 2-3
seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
2. Release the
SETUP key.
3. Press and release the
SETUP key repeatedly until the LCD
touchscreen displays the Key Labels Mode? Screen.
4. If the current component key label is to be changed, make
this change prior to pressing any other LCD key.
5. To change a component key label, press and release the
component key repeatedly until the desired label appears.
If, at any point, you wish to change a component key back
to its original default setting, follow the steps above.
Note: At this point, if you do not wish to change any key
labels within this component, follow steps six and seven.
If you do wish to change key labels within this component,
skip directly to step 5 in the Change LCD Key Labels Within
a Component section below.
6. Press and release the SETUP key on the rubber keypad to
confirm your change.
7. Press and release the LCD OK key to save.
Note: The screen to the right shows ALL of the possible labels,
although only the options for the component you selected are
shown at any one time.
8. To exit the Setup Mode, press and release the LCD EXIT key,
followed by the LCD OK key on the Exit Setup Screen.
Change LCD Key Labels Within a Component
You can change the key labels within a component, if desired. To choose preset key label options
for keys within a component, follow these steps:
1. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and
the touchscreen shows the Code Setup Mode? Screen.
2. Release the SETUP key.
3. Press and release the SETUP key repeatedly until the
LCD touchscreen displays the Key Labels Mode? Screen.
4. From the Key Label Mode? Screen, press and release the
desired component key (
TV, VCR, SAT, etc.) to display
the keys for that screen.
Key Label Options

RCA RCU1010 Specifications

General

Brand	RCA
Model	RCU1010
Category	Remote Control
Language	English