27
Master Reset
4. Press and release the SETUP key or the LCD UP ARROW key
repeatedly until the Set Light On Time? Screen is displayed.
Press and release the LCD OK key.
5. The LCD displays the Light On for 10 Secs Screen (or the
length of time previously programmed). Press and release the
LCD UP or DOWN ARROW keys to select the desired On
Time. You can only change the time in 10-second increments
from 10 to 90 seconds.
Note: The Backlight On Time cannot be set greater than the
LCD display time. Press and release the LCD OK key twice
to confirm and save your settings.
6. The Set More Options? Screen is displayed. The Backlight On
Time setting is now complete. To exit the Setup Mode, press
and release the LCD
EXIT key, followed by the LCD OK key
on the Exit Setup Screen.
A Master Reset returns all the RCU1010 defaults back to the original factory settings. The Master
Reset clears all customer-programmed codes, Learned commands and SmartMacros, and resets
all key labels.
To perform a Master Reset, follow these steps:
1. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
2. Release the
SETUP key.
3. Press and release the SETUP key repeatedly until the Reset
ALL? Screen appears.
4. Press and release the LCD
OK key.
5. The LCD displays the Confirm to Reset? Screen. Press and
release the LCD
OK key. The Please Wait Screen appears and
the LCD touchscreen turns off.
6. All settings are now reset to the factory default.
To Next Page
Loading...
Need help?
General
