16
Clearing all stored Learned commands is recommended before first-time Learning.
To clear all Learned commands, follow these steps:
4. Press and release the desired component key for the Learned
commands you want the RCU1010 to clear (TV, VCR, SAT,
AUX, etc.).
Note: Only the components that have Learned commands are
shown on the LCD touchscreen.
5. The Confirm to Delete? Screen is displayed. Press and release
the
OK key on the LCD touchscreen. The display shows the
Deleting Wait Screen. If there are no other component modes
with Learned commands, the Learn IR Mode? Screen appears.
If there are other component modes with Learned commands,
the Delete IR Mode? Screen is displayed.
6. All Learned commands that were previously programmed
under that mode are now cleared. To exit the Setup Mode,
press and release the LCD
EXIT key, followed by the LCD OK
key on the Exit Setup Screen.
Master Clear
Note: If no commands have been learned, this option is not
shown in the Setup Mode.
1. Press and hold the
SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
2. Release the SETUP key.
3. Press and release the SETUP key repeatedly until the Delete
IR All? Screen appears.
4. Press and release the LCD OKkey.
Note: If, at this point, you wish to abort the Master Clear
operation, press and release the LCD EXIT key.
5. The Confirm to Delete? Screen is displayed. Press and release
the LCD
OK key. The LCD touchscreen displays the Deleting
Wait Screen, followed by the Learn IR Mode? Screen.
6. All Learned commands are now cleared for all
component modes.
7. To exit the Setup Mode, press and release the LCD EXIT key,
followed by the LCD OK key on the Exit Setup Screen.
Clear All Stored Learned Commands Under a Mode (continued)
To Next Page
Need help?
General
