LCD Touchscreen Display Time
24
Additional Features
Keypress Beep Feature
Your RCU1010 beeps whenever a key is pressed to acknowledge the keypress. You can turn this
feature on or off. The default setting is On.
To turn the Keypress Beep on or off, follow these steps:
1. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
2. Release the SETUP key.
3. Press and release the
SETUP key repeatedly until the Set
More Options? Screen appears. Press and release the LCD
OK key. The Set Time? Screen now appears in the LCD.
4. Press and release the SETUP key or the LCD UP ARROW key
repeatedly until the Set Beep? On<>Off Screen is displayed.
Press and release the LCD
OK key.
5. The Set Beep? On<>Off Screen remains in the display with a
solid arrow indicating the current setting. Press and release
the LCD
LEFT or RIGHT ARROW key to select On or Off.
Press and release the LCD
OK twice to confirm and save the
beep state change.
6. The LCD displays the Set More Options? Screen and the beep
change is now complete. To exit the Setup Mode, press and
release the LCD
EXIT key, followed by the LCD OK key on
the Exit Setup Screen.
You can choose the length of time (10, 20, 30 … 90 seconds) that the touchscreen remains on after
the last keypress. The power-on default is 10 seconds from the last keypress. The LCD On Time
cannot be set to a length less than the Backlight On Time.
To change the LCD Touchscreen Display Time, follow these steps:
1. Press and hold the SETUP key on the rubber keypad for
2-3 seconds until the LED indicator light remains on and the
touchscreen shows the Code Setup Mode? Screen.
2. Release the SETUP key.
3. Press and release the
SETUP key repeatedly until the Set
More Options? Screen appears. Press and release the LCD
OK key. The Set Time? Screen now appears in the LCD.
To Next Page
Loading...
Need help?
General
