RCA RPJ065

17
Using Projector Menu 3
Press /MENU button to enter projector menu, press button to select OPTION menu.
This OPTION menu showed on right upper of viewing
screen.
Use button to select different language.
To select different project direction Front Table / Front
Ceiling / Rear Table / Rear Ceiling
To select On / Off
(Active in battery mode, i.e. unplug DC IN jack power.)
Use to select different Aspect Ratio 4:3 / 16:9 / Full
Follow below figure.
Use buttons to select Y or N. If choose “Y” that your
unit will go to factory default setting.
For service center use
only
Aspect Ratio
AV mode
4:3, 16:9, Full, Panorama
HDMI mode
4:3, 16:9, Full, Just Scan
VGA mode
4:3, 16:9, Full
USB / TF input (movie mode)
4:3, 16:9, Full, Panorama, Just Scan
Restore Factory Default
Software Update (USB)
Power Saving Mode On
OSD Language English
Aspect Ratio 16:9
Flip Front Table
OK
OSD Language English
USE
TO SELECT
PRESS OK
t
PRESS OK
USE
TO SELECT
USE
TO SELECT
PRESS OK
t
PRESS OK
USE
TO SELECT
Power Saving Mode On
USE
USE
TO SELECT
PRESS OK
OK
USE
TO SELECT
PRESS OK
t
PRESS OK
USE
TO SELECT
OK
Flip Front Table
USE
TO SELECT
PRESS OK
t
PRESS OK
USE
TO SELECT
t
PRESS OK
USE
TO SELECT
Restore Factory Default
Software Update (USB)
Aspect Ratio 16:9
Note:
1. Power Saving Mode is default On when the unit is active the battery mode.
2. When the Power Saving Mode is turned on, the projection brightness will be dimmed. If
you want to change the brightness, turn off the Power Saving Mode.
3. Plug in the DC supply, the Power Saving Mode is not Active, the projection brightness is
normal.