To Next Page

To Previous Page

Remove & Close The Lens Cover

Placing Your Projector

Your projector can be installed in four different configurations ( see picture

below):

Front Table:

Select this location with the projector placed

near the floor in front of the screen. This is the

most common way to position the projector

for quick setup and portability.

Front Ceiling:

Select this location with the projector

suspended upside-down from the ceiling in

front of the screen.

NOTE: A projector mount is required to install

the projector in a ceiling.

Rear Table:

Select this location with the projector placed

near the floor behind the screen.

NOTE: That a special rear projection screen

is required.

Rear Ceiling:

Select this location with the projector

suspended upside-down from the ceiling

behind the screen.

NOTE:

A projector mount is required to install the

projector in a ceiling.

A special rear projection screen is required.

REMOVE

LENS COVER

Remove the lens cover before using

Close the lens cover when unit not using

FRONT TABLE

REAR TABLE

FRONT CEILING

REAR CEILING

Questions and Answers:

Need help?

Do you have a question about the RCA RPJ119 and is the answer not in the manual?

RCA RPJ119 Specifications

General

Light Source Type	LED
Brightness Output	2000 lumens
Display Native Resolution	800 x 480
Display Color	16.7K
Projection Size	30-100 inch
HDMI Input Supported Video Resolution.	1080p, 1080i, 720p, 576i, 480p, and 480i
Signal Port	Video / VGA / HDMI
USB Port	Support USB device up to 32GB Support format mpeg1, Mpeg2, mpeg4, mp3, Jpeg
SD Card	Support SD card up to 32GB Support format mpeg1, Mpeg2, mpeg4, mp3, Jpeg
Power Consumption	Operating 36W; Standby 0.8W
Power Input Connect Included Adapter	DC 12V, 3.5A
Included Adapter Connect DC input of unit	Input AC100-240V, 50/60Hz Output DC12V, 3.5 A