8
Controls of Remote
Install / Remove Baeries of Remote
Remove the battery compartment cover on the back of the remote by carefully sliding
to open. The battery cover can then be lifted away. Fit the correct batteries (not
included), referring to the polarity markings. Finally, replace the cover.
NOTES:
l
l
l
l
l
l
AAA / UM4
AAA / UM4
BATTERY DOOR
OK
SETUP
Batteries shall not be exposed to
excessive heat such as placing under the
sunlight or near a fire.
Please make sure the batteries are
installed with their correct polarities.
Do not mix old and new batteries.
Use only the same type of batteries.
Do not dispose of the batteries in fire,
battery may explode or leak.
Do not recharge a non-rechargeable
battery.
+-
-+