iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
S-VIDEO
If your video component has a S-Video jack
included, you can make use of it to enjoy
enhanced video quality by connecting it to the
relevant S-Video jack at the rear side of the
receiver One S-video cable is needed for each
component When S-Video cable is used,
composite video (yellow RCA connector) cable
must also be connected for VCR recording
Note: Before plugging in the optical came or
S-Video cable, make sure to match the shape of
the p_ug and jack, otherwise, you will not be able to
plug in completely.
DVD
DIGITAL CONNECTION
If you have a SAT receiver DVD p}ayer or CD player with a digital output, you can make
use of an optical digital cable (not supplied) or coaxial digital cable (not supplied) to
carry the audio portion of the signal and enjoy Dolby Digital sound quality One optical
or coaxial cable is needed for each SAT receiver, DVD player or CD player. When
optical or coaxia} cable is used, the analog audio cables are still needed if recording
through a tape or VCR is desired This receiver provides one optical and one coaxia}
digital input for the connection of your components Please connect your components
(eg DVD, SAT or CD) to the appropriate digital inputs and press D]GITAL INPUT to
select the corresponding digital input source
Note: Optical and coax cables carry only the audio portion of the signal A video
connection must also be established for a SAT receiver and DVD player S-video
provides the best connection for the video portion of the signal Composite video (yellow
RCA connector) can also be used _t is important that the same type of cab}e (S-video or
composite) that is connected from the Home Theater to the TV is used to connect the
SAT receiver or DVD player to the Home Theater
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!i
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiil!
to AUDIO OUT(DaD)
D_G_TAL _NPUT
Connect components
capable of outputing Dolby
Digital (e.g. DVD or SAT) or
standard PCM (CD) format
digita_ signals Read section
on "input Signal Setting"
under "Advanced Sound
Control" carefully to adjust
the matching input settings
CD Player
Tape Deck
(Tape Deck)
_ _I ] I E]'I 14t° LINE IN { TapeDec< )
If your CD player is equipped with digital optical jacks, use of optical cable is preferred
What you need is just one more optical digital connecting cable (not supplied) Plug it in
........................ the digital input jack of the receiver and se}ect OPTICAL on the receiver setting (see
details on pg 19 chapter "Input Signal Setting"). You can enjoy better sound quality
brought to you by the optical cable When optical cable is used, analog cables are still
................................ needed for recording to tape output
SAT
TV
VCR
o:. I_ o o_ I
FRONT TERMINAL
Remark: If you have a video camera,
video game machine, or an extra
VCR, connect it to VAUX input at the
front of the receiver
To Next Page
Loading...
Need help?
General
