To Next PageTo Next Page
Need help?Do you have a question about the RCGF 30CC-Twin and is the answer not in the manual?
Details engine type, displacement, bore, stroke, carburetor, ignition, power, output, requirements, speed range, fuel mix, lubrication, and propeller.
Lists the weight of the engine, mufflers, and ignition module.
Provides ignition battery, fuel mix, spark plug, idle speed, and static thrust data.
Lists the specific parts included in the RCGF 30cc twin engine package.
Emphasizes safety during operation, handling, and around the engine.
Covers safe propeller use, foreign object avoidance, and fuel line considerations.
Details fuel/oil mixing ratios and general operating precautions.
Covers initial checks and preparation before mounting the engine.
Details connecting the ignition module, pick-up lead, and kill switch.
Guides on securing the ignition module and installing the kill switch and charge jack.
Details firewall requirements and mounting the engine using standoffs and hardware.
Explains how to install the fuel tank, lines, and stopper for proper fuel delivery.
Guides on installing throttle and choke servos and non-metallic linkage.
Covers connecting the spark plug wire, muffler, cowl, and linkages for operation.
Explains how to drill a propeller using a drill guide or manual method.
Details the process of marking and drilling the propeller mounting holes.
Guides on securely mounting the propeller to the engine crankshaft.
States that the engine is factory preset but minor adjustments may be needed.
Explains how to adjust the idle speed using the idle adjustment screw.
Details how to adjust the fuel/air mixture at low speeds.
Details how to adjust the fuel/air mixture at high speeds for optimum performance.
Explains how to adjust the ignition timing for performance or timing issues.
Provides solutions for engine hesitation, stalling, or rough idling related to low-speed needle.
Offers solutions for engine stopping at full throttle or not reaching max RPM related to high-speed needle.
Provides step-by-step instructions for manually starting the engine.
Guides on starting the engine using an electric starter.
Lists common causes and fixes for the engine not firing.
Addresses issues where the engine starts but then stops, checking fuel delivery.
Explains how to connect an optional digital tachometer to monitor RPM.
Details using a Y-harness for older ignition modules to connect the tachometer.
Instructions on how to clean the fuel filter in the carburetor to ensure calibration.
Shows the carburetor gasket, carb filter, and fuel filter components.
States the warranty duration and proof of purchase requirement.
Provides the official websites for RCGF engine information and service.
Identifies engine components with item numbers and corresponding accessory numbers.
General| Displacement | 30cc |
|---|---|
| Configuration | Twin Cylinder |
| Stroke | 24mm |
| Carburetor | Walbro |
| Ignition | RCEXL |
| Spark Plug | NGK CM6 |
| Recommended Propeller | 16x8, 17x6, 18x6 |
| Engine Type | Gasoline |
| Power Supply | 4.8-8.4V |
| Gasoline/Oil Mix | 25:1 |
