Figure 15. Lineout for the RC gear in the fuselage: Before you buy the RC gear think about the way you want
to install it in the fuselage. I found that parallel installment of two KST 215 servos in conjuntion with 2
lithium ion batteries placed in front of the servos gives me plenty of space in the fuselage for all other RC
gear needed, see figure. This figure is therefore, plainly meant as one example how the RC gear could be
placed in the fuselage. Note, the receiver sits on top of the battery. Moreover, be sure to keep enough
distance between servo board and ballast tube so that you can firstly, still mount the tube and secondly,
load and unload the ballast conveniently.
Once you have estimated the perfect positioning for your RC gear including the servos, design your
servo board and laminate it into the fuselage, see figure 16.
To Next Page
Loading...
