2
Contents of the Strega Manual
Introduction
.........................................................................................................................................................
2
Materials needed
.................................................................................................................................................
3
Strega-Kit
.........................................................................................................................................................
3
Additional materials required
.........................................................................................................................
3
A few added and some replaced parts
............................................................................................................
4
Preparations and assembly of parts:
...................................................................................................................
4
Sanding the sealing lips
...................................................................................................................................
4
Installation of control horns in the wings
.......................................................................................................
5
Installation of the wing servos
........................................................................................................................
7
(Making and) mounting the servo board
......................................................................................................
16
V-Tail linkage
.................................................................................................................................................
18
Ballast tube
....................................................................................................................................................
19
Setup of the plane
..............................................................................................................................................
21
Flying Strega
......................................................................................................................................................
23
Introduction
The RC glider Strega from RCRCM is a full on F3F/F3B sports model. It is ideal for the ambitioned RC
amateur pilot who wants a high end all-round glider that features excellent thermal flying- but also
speed flying- capabilities. In addition, the Strega cuts through hard transitions smoothly and will also
promptly follow your commands through basic aerobatic maneuvers.
I prepared this assembly guide for the medium experienced craftsman. Therefore, I have
described all assembly steps that I deem critical for proper function of the plane. Knowledge of
standard techniques such as use of epoxy resin, soldering cables and plugs, as well as
preparation/choice of batteries and RC equipment, is required. In a few cases I used materials that
are not supplied with the kit. There, more detailed explanations- as well as the reasons for the
changes- are given. I actually really enjoyed the building process of the Strega and, I wish you a lot of
fun building it yourself! At the end of this guide there will also be a section on the RC-setup of the
plane and on flying it.
To Next Page
Loading...
