washer (Fig. 13).
2.Connect the bottle to the gun lance.
Detergent bottle installation is same as
nozzle installation.
3. Adjust foam spraying amount by adjusting
the valve (Fig. 13).
CAUTION! Always test the detergent in
an inconspicuous area before use.
4.Turn on the pressure washer. Pull the
trigger to operate the unit. The liquid
detergent will automatically mix with water
and be discharged through the nozzle.
5. Apply detergent from the bottom to the top
of the dry surface to be cleaned.
NOTE: Wetting the surface first is not
recommended as it dilutes the detergent
and reduces its cleaning ability.
6.Allow the detergent to remain on the
surface for a short time before rinsing. Do
not allow the detergent to dry on the
surface.
CAUTION! Damage may occur to painted
surfaces if the detergent is allowed to dry
on the surface. Wash and rinse a small
section at a time. Avoid working on hot
surfaces or in direct sunlight.
7.When you have finished using the
detergent injection system, insert the bottle
detergent with fresh water. Siphon water at
low-pressure for one minute to rinse the
bottle until it is thoroughly cleaned.
CAUTION!
Failure to follow these
cleaning instructions will cause the
injection system to become clogged and
inoperable.
Working with Patio
Cleaner (optional)
The patio cleaner is a powerful accessory
for cleaning patio, driveways, etc.
1. Insert the extension lance (A) into to the
housing (B) (Fig.14).
2. Fix the extension lance (A) with the two
screws to the housing (B).
3. Insert the rotor arm (C) into the extension
lance.
4. Insert the U-pin (D) to fix the rotor arm (C).
To Next Page
Loading...
