NOTE: Make sure the rotor arm (C) is
properly fixed to the extension lance (A)
with the U-pin (D).
NOTE: Do not use the Patio Cleaner as a
broom but let it surf smoothly over the
5. Connect a patio cleaner to the spray wand
same as the installation of nozzle.
Working with Angle
Nozzle (optional)
The angle nozzle can be used for many
applications e.g. cleaning the underbody
of a car, underneath a lawn mover without
being splashed back with debris, etc.
Snap the quick- connect angle nozzle to
the spray wand same as the installation of
nozzle.
Rinsing with the
pressure washer
1.Turn off the pressure washer and shut off
the water supply.
2.Pull the trigger to release water pressure.
3.Engage the safety lock on the trigger
handle by pushing right on the safety
lock(Fig.10)
4. Remove the nozzles from the spray lance
and storage them properly(Fig.15).
5. Start at the top of the area to be rinsed
and work down, making sure to overlap
the strokes.
IMPORTANT! NEVER USE:
• Bleach, chlorine products, and other
• Liquids containing solvents (e.g. paint
thinners, gasoline, oils)
• Tri-sodium phosphate products
These chemicals will harm the unit and
will damage the cleaning surface.
Shutting Down
1.
Turn the switch to the OFF position and
unplug the power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the
5. Disconnect the high pressure hose
connection on the trigger gun handle.
6. Release the trigger and engage the
gun safety lock.
WARNING! Turn off the water supply
and squeeze the trigger to depressurize
the unit. Failure to do so could result in
personal injury due to discharge of high-
pressure water.
Storage
CAUTION! Always store your pressure
washer in a location where the
temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to
permanent damage if it freezes. FREEZE
DAMAGE IS NOT COVERED BY THE
WARRANTY.
To Next Page
Loading...
