Reaim BCO-H - Technical Data

5
Technical data
Motor
Brush
Max. pressure
2100PSI
Max flow
1.6GPM
Current
13A
Voltage
120V~/60Hz
Water
temperature
40℃
The Circuitry
SAFETY DEVICES
The unloader valve can reduce pressure if it
exceeds pre-set values.
Locking device on trigger gun (see
illustration at the beginning of this manual)!
The trigger gun features a locking device.
When the knob is activated, the trigger gun
cannot be operated.
THERMAL SENSOR
A thermal sensor protects the motor against
overloading. The machine will restart after a
few minutes when the thermal sensor has
cooled.
Assembly
1. Position the washer as CLOSE as
possible to the water supply.
2. The washer must be used on a secure
and stable surface in a standing, upright
position (Fig. 1).
3. Screw the transaction handle to the
electric pressure washer unit(Fig. 2).
4. Insert the gun holder and power cord
holder to the electric pressure washer
unit(Fig. 3).
Fig.3
Fig.2