5. Snap the spray wand into the trigger gun
and rotate it until the two parts are
completely locked. (Fig.4)
6. Insert the high-pressure hose to the
trigger gun by pressing the pawl A, then
insert another end of high-pressure hose
to the water outlet by pressing button B
(Fig. 5).
WARNING! Keep hose away from sharp
objects. Bursting hoses may cause injury.
Examine hoses regularly and replace if
damaged. Do not attempt to mend a
damaged hose.
7. Connect the garden hose adapter (female
coupler) to the water inlet of the pressure
washer, then thread your garden hose
(male end) into the garden hose adaptor
(Fig. 6). The water supply must be at least
equal to the washer delivery capacity.
NOTE: The machine is not suitable for
connection to a potable water main.
8. Attach garden hose to water supply (Fig.
7).
WARNING! The intake water
temperature must not exceed 104ºF/40ºC.
CAUTION! The washer must only be
used with clean water; use of unfiltered
water containing corrosive chemicals will
damage the washer.
Let the water run through the water hose
before connecting it to the machine to
prevent sand and dirt from penetrating
the machine.
Note: Check that the filter is fitted in the
garden hose adaptor and that it is not
clogged up.
To Next Page
