·Store in a dry, covered area where it is not
subject to adverse weather conditions.
· It is important to store this product in a
frost-free area.
· Always empty water from all hoses, the
pump, and the detergent bottle before
storing.
CAUTION!The use of a pump protector is
recommended to prevent cold weather
damage during storage over the winter
months.
Winterizing and
Long-Term Storage
If you must store your pressure washer in
a location where the temperature falls
below 32ºF (0ºC), you can minimize the
chance of damage to your machine by
utilizing the followingprocedure:
·Disconnect all water connections.
· Turn on the machine for a few seconds
until the remaining water in the pump
exits. Turn off immediately.
· Do not allow the high-pressure hose to
become kinked.
· Store the machine and accessories in a
room that does not reach freezing
temperatures.
· Do not store near a furnace or other
sources of heat that may dry out the
pump seals.
· Operate the pressure washer with non-
corrosive/non-toxic anti-freeze, a pump
saver, or a pump protector before storing
for the winter.
WARNING!Before reusing, completely
flush the unit out with clear water. Anti-
freeze products can damage paintwork,
so you must ensure there is no anti-freeze
left in the system before using it again.
CAUTION!
Before working on the
pressure washer, disconnect the plug from
the power supply socket.
1. To ensure good performance, check and
clean the water inlet filter (Fig. 16).
Remove the filter and rinse with water to
prevent any foreign matter from clogging
the pump (Fig. 17).
2. Clean the nozzle with the needle clean out
tool provided (Fig. 18). Remove the spray
lance from the gun; remove any dirt from
the nozzle hole and rinse.
To Next Page
Loading...
