Optional Function settings
You can change the settings of the scanner by scanning the setup bar codes included
in this manual.
1. Scanning Mode Setting
Supporting three kinds of scanning modes.
1.1. Manual Trigger mode (default) :
Press the trigger, the scanner will emit light and read the barcode. Release the trigger,
the scanner will stop reading barcode and the light will go off.
** Scan the following codes to set the scanner to Manual trigger mode .
Manual trigger mode (default)
1.2. Continuous Scanning Mode
There’s no need to press the trigger in this mode. The green light of the scanner will be
on at a certain frequency.
The green scanning light will go off once the scanner scans barcode successfully and
the scanner will enter into next scanning automatically after a intermittent time . And
the green scanning light of the scanner will be on again once the waiting time passes.
To Next Page
Loading...
