Need help?Do you have a question about the REALINN RL6200W and is the answer not in the manual?
Instructions for connecting and configuring the scanner in wireless mode.
Instructions for connecting and configuring the scanner in wired mode.
Configure settings for uploading scanned data in instant or storage modes.
Select between manual trigger, continuous, and auto-sensing scanning modes.
Adjust the volume or turn off the beep sound for scanner feedback.
Set time intervals to prevent repeated scanning of the same barcode.
Configure aiming beam and LED light modes for better scanning performance.
Set scanner to convert scanned barcode characters to uppercase or lowercase.
Reset the scanner to its default factory settings.
Identify and manage supported barcode types for accurate scanning.
Configure end characters (e.g., Carriage Return, TAB) after scanning.
Configure USB-HID or USB virtual COM modes for scanner communication.
Check the current battery level of the scanner.
Set the time interval before the scanner enters stand-by mode.
Set the keyboard language for wireless mode operation.
Enable or disable specific 1D and 2D barcode types for scanning.
Configure settings to hide characters from the beginning of a scanned barcode.
Configure settings to hide characters from the end of a scanned barcode.
General| Operating Frequency | 2.4GHz |
|---|---|
| Scan Rate | 300 scans per second |
| Interface | USB |
| Power Supply | Rechargeable battery |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -20°C to 60°C |
To Next Page
