2.3. Auto-Sensing Mode
There’s no need to click the trigger under the Auto-sensing Mode. Just move the
barcodes in front of the scanner, a green light band will show up to read the barcode.
The green light band will go off once the scanner scans barcode successfully or preset
timeout expires.
** Scan the following codes to set the scanner to Auto-induction Mode .
.
Auto-sensing Mode
Note： In Auto-sensing Mode. It will be better to set the scanner out to be longer
stand-by time interval. Please refer to the instruction on page 18.
3. Beep Setting
Beep-Off
Low volume
Medium volume
To Next Page
Loading...
