2. Scanning Mode Setting
Supporting three kinds of scanning modes.
2.1. Manual Trigger mode (default) :
Press the trigger, the scanner will emit light and read the barcode. Release the trigger,
the scanner will stop reading barcode and the light will go off.
** Scan the following codes to set the scanner to Manual trigger mode .
Manual trigger mode (default)
2.2. Continuous Scanning Mode
There’s no need to press the trigger in this mode. The green light of the scanner will be
on at a certain frequency.
The green scanning light will go off once the scanner scans barcode successfully and
the scanner will enter into next scanning automatically after a intermittent time . And
the green scanning light of the scanner will be on again once the waiting time passes
** Scan the following codes to set the scanner to Continuous Scanning Mode.
.
Continuous Scanning Mode
To Next Page
Loading...
