preparation
You can operate your transceiver from any of the following sources:
Rechargeable power pack (supplied with charger)
Six alkaline AA batteries (using the supplied alkaline pack)
Vehicle battery power (using optional adapter)
OPERATING FROM THE RECHARGEABLE POWER PACK
You can use the supplied rechargeable power pack to power your
transceiver.
This power pack provides 7.2 volts and can operate your transceiver at 2.5
watts(typical power) with the low power button out. As supplied, the power
pack is fully discharged. You need to fully charge the pack using the
supplied charger before you operate the transceiver from the rechargeable
pack. Follow these steps to charge the pack.
1. If the pack is attached to the transceiver, turn off the transceiver.
Do not operate the transceiver while charging the pack.
NOTE: You can remove the power pack from the transceiver to charge it,
and operate the transceiver from one of the other power sources.
2. Plug the supplied charger's barrel plug into the CHARGE jack on the
back of the power pack.
3. Plug the charger into a standard AC outlet. The CHARGE indicator
lights.
It takes about 10 hours to charge the power pack.
When power is low, BATT appears on the display when you press PTT.
You
can buy extra power packs through your local Radio Shack store.
To Next Page
Loading...
