Need help?Do you have a question about the Realistic STA-95 and is the answer not in the manual?
General| Tuning Range | FM, MW |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal-to-Noise Ratio | 70dB (MM) |
| Speaker load impedance | 4Ω to 16Ω |
Detailed technical specifications for the FM reception capabilities, including tuning, sensitivity, and selectivity.
Technical specifications for the stereo multiplex decoder, focusing on separation and distortion.
Detailed technical specifications for the AM reception capabilities, including tuning, sensitivity, and distortion.
Visual representation of the receiver's internal signal paths and component interconnections.
Procedures for dismantling the receiver chassis and front panel for servicing.
Diagram illustrating the correct routing of the dial string for the tuning mechanism.
Procedures for calibrating the AM tuner section's intermediate frequency and radio frequency circuits.
Procedures for calibrating the FM tuner section's radio frequency and intermediate frequency circuits.
Steps for aligning the FM stereo multiplex decoder for accurate stereo separation.
Adjustment procedure for the main audio amplifier stage.
Identification of specific points and components for alignment checks and adjustments.
Graph illustrating voltage gain characteristics across different stages of the audio signal path.
Comprehensive guide to diagnosing common symptoms and their corresponding causes and remedies.
Diagrams showing the lead configurations for various semiconductor devices used in the receiver.
Comprehensive list of electronic components (capacitors, coils, transformers, resistors, etc.) with their specifications.
Detailed listing of transistors used, including type numbers, manufacturers, and substitutes.
Listing of miscellaneous parts such as hardware, switches, and lamps not covered in other lists.
To Next Page
