Antenna Placement Within the Laptop and Tablet Host Platform:
This module is authorized for installation in qualified laptops (i.e. notebooks and netbooks), and
tablets with overall diagonal dimension of the keyboard and/or display section is > 20 cm. To
ensure RF exposure compliance the antenna(s) used with this module must be installed in host
platforms to provide a minimum separation distance, in all operating modes and orientations of the
host platform. The separation distance is measured from the antenna and the outer surface of host
platform in all directions for portable exposure conditions. The antenna separation distance applies
to both horizontal and vertical orientation of the antenna when installed in the host system. This
module must not be co-located with any other RF modules or transmitters. Additional SAR
evaluation would be required if other RF modules or transmitters are co-located with this module.
The required minimum separation distance for the antenna placement is outlined below:
For antenna located in the keyboard section of Laptop platform: ≥ 5 mm from the antenna
to the bottom surface of keyboard section.
For antenna located in the display section of Laptop platform: ≥ 5 mm from the antenna to
the bottom surface of keyboard section.
For antenna located in Tablet platform: ≥ 10 mm from all surfaces and edges of the tablet.
This module is not approved for installation in hosts with multiple or additional transmitters.
Additional FCC equipment approval is required for installation in such hosts.
To Next Page
Loading...
