Need help?Do you have a question about the Recent RS-918SSB and is the answer not in the manual?
Explains M1 button usage for selecting settings and values via Encoder 1.
Explains M2 button usage for selecting settings and values via Encoder 2.
Explains M3 button usage for selecting settings and values via Encoder 3.
Lists and describes parameters within the mcHF's Standard Menu.
Parameters for configuring the mcHF's operational settings.
Settings related to the display's appearance and behavior.
Configuration options specifically for the CW (Morse code) operating mode.
Settings for selecting and configuring audio filters for different modes.
Settings related to the Power Amplifier (PA) configuration and tuning.
Displays information about the mcHF's hardware and software components.
Settings for debugging and experimental features.
Procedure for calibrating the touchscreen interface for proper operation.
Instructions to set the correct orientation for the SWR/Power meter readings.
Steps and requirements for calibrating the Power Amplifier (PA) output power.
Guide for adjusting the bias on the mcHF RF board for older firmware versions.
Steps to set and adjust RF power output levels for transmission.
Adjustments for IQ phase and gain balance for transmit paths.
Methods for adjusting IQ phase and amplitude imbalances in the receive path.
Steps to calibrate the zero offset for the SWR/Power meter.
Adjustments to calibrate power meter coupling factors for various bands.
Method for calibrating frequency during transmission using a frequency counter.
Method for calibrating frequency during reception using broadcast stations.
Instructions for enabling and using the CW Tune Helper features.
Explanation of the automatic tuning process based on FFT analysis.
A quick guide on how to adjust and use the WDSP AGC.
How to switch between Standard AGC and WDSP AGC modes.
Predefined parameter sets for AGC modes and their decay times.
How to adjust the AGC threshold for optimal performance.
How to enable and configure the Hang AGC feature.
Description of the FreeDV digital mode.
Instructions for operating RTTY mode, including filter and baud rate settings.
How to tune the CW decoder for optimal performance.
Adjusting the threshold for CW signal detection.
Steps for receiving PSK signals.
How to use the keyer functionality, including macro recording.
List of functionalities enabled by USB CAT and Audio interface.
How to enable or disable USB CAT and Audio features.
Software applications for controlling the transceiver's functions.
Software for digital mode operation (FLDigi, WSJT-X, etc.).
Specific driver installation for Windows Vista and later.
Specific instructions for installing drivers on Windows XP.
Troubleshooting no audio output/input with USB Audio.
Troubleshooting serial port detection issues on Linux systems.
How to snap to frequency step grids using SNAP.
How to cycle through TX modulation input options.
Details on receiver sensitivity across different bandwidths.
Overview of the transceiver's technical specifications.
The frequency ranges for transmit and receive operations.
Explanation of Spectrum Scope and Waterfall Display modes.
FM receiver sensitivity specifications at various bandwidths.
Noise reduction and notch filter capabilities.
Description of audio ports and PTT connection.
Current consumption details during receive mode.
Current consumption details during transmit mode at different power levels.
General| Brand | Recent |
|---|---|
| Model | RS-918SSB |
| Category | Transceiver |
| Language | English |
To Next Page