SSB TX Audio
Filter2 (CONFIG_SSB_TX_FILTER)
Select if SSB-TX signal is filtered
(strongly recommended to agree to
regulations)
PA Configuration (MENU_POW)
Tune Power Level (CONFIG_TUNE_POWER_LEVEL)
Select the power level for
TUNE operation. May be
set using the selected
power level or have a fixed
power level.
Tune Tone (SSB) (CONFIG_TUNE_TONE_MODE)
Select if single tone or two
tone is generated during
TUNE operation. Not
persistent.
CW PA Bias (If >0) (CONFIG_CW_PA_BIAS)
If set to a value above 0,
this BIAS is used during CW
transmission; otherwise
normal BIAS is used during
CW
Reduce Power on Low
Bands (CONFIG_REDUCE_POWER_ON_LOW_BANDS)
If set (recommended!)
frequencies below 8Mhz
(40m or lower) require
higher power adjust values
(four times). This permits
better control of generated
power on these
frequencies.
To Next Page
Loading...