FM Sub Tone
Dot (MENU_FM_DET_SUBAUDIBLE_TONE)
Enable detection of CTCSS tones
during FM receive. RX is muted
unless tone is detected.
FM Tone
Burst (MENU_FM_TONE_BURST_MODE)
Enabled sending of short tone at
beginning of each FM
transmission. Used to open
repeaters. Available frequencies
are 1750 Hz and 2135 Hz.
FM Deviation (MENU_FM_DEV_MODE)
Select between normal and
narrow deviation (5 and 2.5kHz)
for FM RX/TX
AGC WDSP Mode (MENU_AGC_WDSP_MODE)
Choose a bundle of preset AGC
parameters for the WDSP AGC:
FAST / MED / SLOW / LONG /
very LONG or switch OFF the
AGC.
AGC WDSP Slope (MENU_AGC_WDSP_SLOPE)
Slope of the AGC is the
difference between the loudest
signal and the quietest signal
after the AGC action has taken
place. Given in db.
AGC WDSP
Decay (MENU_AGC_WDSP_TAU_DECAY)
Time constant for the AGC decay
(speed of recovery of the AGC
gain) in milliseconds.
AGC WDSP
Threshold (MENU_AGC_WDSP_THRESH)
´Threshold´ = ´Knee´ of the AGC:
input signal level from which on
the AGC action takes place. AGC
threshold should be
placed/adjusted just above the
To Next Page
Loading...