www.reconyx.com 18
Mounting Your Camera
Your RECONYX™ HyperFire
TM
camera can be mounted to a RECONYX™
VersaMount™, ThunderBolt™, or camera tripod by utilizing the threaded insert
on the back of the camera housing.
The camera may also be mounted to a tree by using the included adjustable
bungee cord (shown below). Simply thread the end without the loop through the
“Lock Tunnel” on the camera and then install the included adjustable bungee
hook to the length needed and fasten to the tree.
Mounting Camera with Adjustable Bungee Cord (included)
For general surveillance we recommend that you mount your camera about chest
height. This is optimal for detecting people within the field of view of the camera
as well as for accessing the camera’s card, batteries, and controls.
If you are concerned about someone seeing the camera during daylight hours,
you can mount the camera a bit higher and angle it down a little more. Most
people do not often look up and therefore are less likely to notice the camera if it
is mounted a few feet higher.
NOTE: It is highly recommended that you use a theft deterrent device such
as a security box and/or a Master Python Lock™ to help secure your
camera against possible theft when it is in the field.
TIP: You can purchase HyperFire™ compatible theft deterrent cables, locks and
security enclosures at www.reconyx.com
To Next Page
Loading...
