EasyManua.ls Logo

Record 102-020.110.805 - User Manual

Record 102-020.110.805
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Maintenance and troubleshooting
record sliding door system 20
Manufacturer: Distributor:
agtatec ag
Allmendstrasse 24
CH-8320 Fehraltorf
Switzerland
Tel. no. : +41 44 954 91 91
Fax. no. : +41 44 954 92 00
www.agta-record.com
Copyright by agtatec ag, CH-8320 Fehraltorf September 2009 Article no. 102-020.110.805

Questions and Answers

  • F
    fischerbrandonSep 9, 2025
    What to do if Record Door Opening System displays 'RED VRR test'?
    • C
      Cheryl ColeSep 9, 2025
      If the Record Door Opening System displays 'RED VRR test', check the setting of the locking device.
  • B
    brad07Aug 25, 2025
    What to do if Record 102-020.110.805 shows 'Unlocking error'?
    • S
      samantha38Aug 25, 2025
      If the Record Door Opening System displays an 'Unlocking error', repeat the unlocking attempt after changing the BDE operating mode. If the door remains locked, switch to MANUAL operating mode and use the hand unlocking device (if available), then select AUTOMATIC mode, reset the hand unlocking device, and check the locking device.
  • J
    jameshallAug 25, 2025
    What to do if Record Door Opening System displays 'Encoder fault'?
    • D
      David TuckerAug 26, 2025
      If the Record Door Opening System displays 'Encoder fault', reset the system. This may resolve the issue if the encoder or cable is faulty or not properly connected.
  • A
    alexandra62Sep 23, 2025
    Why Record 102-020.110.805 Door Opening System displays 'Batt. not charged complet.'?
    • J
      Jeffrey JenkinsSep 23, 2025
      The 'Batt. not charged complet.' message on your Record Door Opening System indicates that the battery is not fully charged. The message will disappear from the display once the battery is fully charged.
  • J
    James HowardSep 9, 2025
    What to do if Record Door Opening System displays 'VOK closed l.'?
    • R
      rmaySep 10, 2025
      If the Record Door Opening System displays 'VOK closed l.', change the operating mode on BDE-D to Automatic and then back to Locked. The locked position may be incorrect, or the VRR may be faulty.
  • M
    Michael LawrenceSep 14, 2025
    What does 'Calibrating run' mean on Record Door Opening System?
    • R
      Rachel JohnsonSep 14, 2025
      The 'Calibrating run' message on your Record Door Opening System is a warning that a calibration run is being performed.
  • E
    Erica VaughanSep 4, 2025
    What to do if Record 102-020.110.805 Door Opening System displays 'SSK > 60 sec. active'?
    • J
      Jason AndrewsSep 4, 2025
      If the Record Door Opening System displays 'SSK > 60 sec. active', control the SSK-switch and wiring/connections. The door may be locked.
  • J
    Joseph BarnesSep 4, 2025
    What to do if Record 102-020.110.805 displays 'STG relay defect.'?
    • S
      Stephanie JonesSep 4, 2025
      If the Record Door Opening System displays 'STG relay defect.', change the control unit.
  • T
    Taylor MurphySep 23, 2025
    What does 'Battery fuse open' mean for Record 102-020.110.805?
    • Y
      Yesenia SparksSep 23, 2025
      The 'Battery fuse open' message on your Record Door Opening System indicates that the battery fuse is disconnected or the battery is not plugged in. The door will function if mains voltage is supplied and it is not a RED installation, or if the parameter "Basic escape route" is not activated.
  • A
    Anne SmithAug 29, 2025
    What to do if Record 102-020.110.805 displays 'Error ELS1'?
    • C
      chenkatieAug 30, 2025
      If the Record Door Opening System displays 'Error ELS1', calibrate ELS with 2 light pulses.

Summary

General remarks

Goal and application field of maintenance and service

Describes the purpose and scope of the maintenance and troubleshooting instructions for the record system 20.

Definitions

Explains key terms and symbols used in the document for clarity and readability.

Safety instructions

Use for the intended purpose

Specifies the intended application of the record system 20 and the operator's responsibility.

General safety and accident prevention regulations

Outlines general safety rules and accident prevention measures for operating the sliding door system.

Instructions for maintenance and service

Preparations

Lists necessary special tools, aids, and documents for efficient maintenance.

Schedule of periodical maintenance

Details regular maintenance tasks including cleaning, mechanical checks, and functional controls.

Administration

Covers administrative tasks like informing the operator and signing service reports.

Logbook

Explains the purpose and format of the logbook for recording maintenance and interventions.

Repairs

System information on BDE-D

Explains how to read operator system information, software versions, and phone numbers from the BDE-D display.

Error display and troubleshooting

Details how the BDE-D displays errors and how to interpret them for troubleshooting.

Common error displays

Lists and explains common error messages, abbreviations, and symbols for troubleshooting.

Error display of additional units on CAN bus (only with FPC)

Explains 4-digit error codes for additional units on the CAN bus and their troubleshooting.

Taking out of service and disposal

Taking out of service

Describes the procedure for disconnecting the record system 20 from power and battery.

Dismantling and disposal

Provides guidance on sorting and disposing of machine parts according to regulations.

Record 102-020.110.805 Specifications

General IconGeneral
BrandRecord
Model102-020.110.805
CategoryDoor Opening System
LanguageEnglish

Related product manuals