Need help?Do you have a question about the Record STA20 and is the answer not in the manual?
General| Power supply | 230 V AC, 50/60 Hz |
|---|---|
| Hold-open time | 0 – 60 s (adjustable) |
| Opening speed | 0.15 – 0.7 m/s (adjustable) |
| Closing speed | 0.15 – 0.7 m/s (adjustable) |
| Operating temperature | -20°C to +55°C |
Select language, enter programming mode, configure system, and choose door type.
Initiate learning system, run parameters, and confirm door closure.
Details control board connections, CAN bus, and wiring for RIC290/AIS290 sensors.
Identifies RIC290/AKA/AKI and AIS290 sensors, including AND/OR options.
Settings for AKI, SI, AKA, SA and DIP switch configuration for RIC 290 sensors.
Adjust sensors for EN16005 compliance and site needs via BDED for sensitivity and field of detection.
Parameters for closing/opening speed, acceleration, deceleration, creep section, and ramp settings.
Parameters for collision reaction points during opening/closing and brake engagement.
Configuration of Extended Function Modules (FEM-1, FEM-0) and their inputs/outputs.
Assignment of signals for sensors, buttons, and safety inputs like SÖK, NSK, SIS, SIO on STM modules.
To Next Page
