RED DSMC OPERATION GUIDE
COPYRIGHT © 2013 RED.COM, INC
955-0020_V5.1, REV-D | 97
Low Power Preview: The camera uses a lower amount of power after the specified period of inactivity.
Sleep: All monitors turn off and keys will not perform mapped actions after the specified period of inactivity.
Touch the screen or press a key to exit Sleep mode.
Auto Shutdown: The camera shuts down after the specified period of activity.
SHUTDOWN
Shutdown controls are interlocked to prevent accidental powering down of the camera. For details on the dif-
ferent ways to power down your RED DSMC Camera, go to “Power Down” on page 42.
1. Go to Menu > Power.
2. Select Shutdown.
The camera immediately powers down.
HDR MENU
NOTE: HDR mode cannot be modified when in Magnify 1:1 mode or when test signals are enabled.
NOTE: You cannot use HDR mode in any of the following situations:
‒ On an EPIC DRAGON or SCARLET DRAGON (the HDR menu is not accessible on these cameras).
‒ A MOTION MOUNT is installed.
‒ A Sensor Sync Mode (Genlock or MoCo) is enabled.
‒ Speed Ramp mode is enabled.
‒ A Frame Processing mode (Frame Summing or Frame Averaging) is enabled.
By default HDRx is disabled, and the HDR text in the Lower Status Group of the Viewfinder screen is gray.
To enable HDRx, follow the instructions below:
1. Go to Menu > HDR.
2. Select HDRx.
3. Select the number of Stops. The range is 1–6, and the default is 2.
The HDR text in the Lower Status Group of the Viewfinder screen turns white.
To Next Page
Loading...
