MAINTENANCE
Troubleshooting
888.885.9254 | redlionproducts.com
For technical assistance, parts, repair, or warranty information, please contact:
Form 998777 Rev. 000 01/20
Copyright © 2020, Franklin Electric, Co., Inc. All rights reserved.
Troubleshooting
Replacement Parts and Accessories
If products are not available at your local retailer, contact Technical Service at 888.885.9254 for ordering
information.
Problem Probable Causes Corrective Action
Pump does not
turn on
Pump not plugged in. Connect pump power cord to a GFCI circuit.
Circuit breaker off or fuse removed. Turn on circuit breaker or replace fuse.
Corroded power cord plug prongs. Clean prongs on power cord plug.
Tripped overload. Allow pump to cool, investigate cause (i.e. jammed impeller).
Defective motor. Replace pump.
Pump runs but
does not dis-
charge fluid
Blocked or jammed impeller. Clean impeller; refer to “
Maintenance” on page 3.
Suction lift is too high. Reduce the pump height to water source.
Inlet to impeller plugged. Pull pump and clean, refer to “
Maintenance” on page 3
Pump does not
deliver rated
capacity
Lift too high for pump. Check rated pump performance.
Partially blocked inlet. Clean inlet.
Impeller or discharge pipe is clogged. Pull pump and clean. Check hose for kinks or blockage.
Impeller wear due to abrasives. Replace pump.
Item Part Number Description
1 14942729 Discharge/Adapter Kit contains 3/4" discharge, seals, hardware and 1-1/4" FNPT adapter
2 599002 SA-1 Sacrifical Anode (Optional accessory)
3 599304 Universal 24' Hose Kit with 1-1/4" and 1-1/2 adapters (Optional accessory)
4 14942904 Vertical float switch with 10' cord (Optional accessory)
5 640171 Tethered float switch with 10' cord (Optional accessory)
To Next Page
Loading...
Need help?
General
