1
RS SERIES INVERTERS (350W)
REDARC Pure Sine Wave Inverters produce a pure sine wave output. This means that the power
output from a REDARC Pure Sine Wave Inverter is not only the same as the mains supply, it’s often
better!
WARNINGS & SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains IMPORTANT SAFETY INSTRUCTIONS for the
REDARC RS series 350W Pure Sine Wave Inverters.
DO NOT OPERATE THE INVERTER UNLESS YOU HAVE READ AND UNDERSTOOD THIS MANUAL AND THE
INVERTER IS INSTALLED AS PER THESE INSTALLATION INSTRUCTIONS. REDARC RECOMMENDS THAT
THE INVERTER BE INSTALLED BY A SUITABLY QUALIFIED PERSON.
1. RISK OF ELECTRICAL SHOCK. DO NOT DISASSEMBLE THE INVERTER - THE INTERNAL CIRCUITRY
CONTAINS HAZARDOUS VOLTAGES. ATTEMPTING TO SERVICE THE UNIT YOURSELF MAY RESULT
IN ELECTRIC SHOCK OR FIRE AND WILL VOID THE UNIT WARRANTY.
2. RISK OF ELECTRICAL SHOCK. DO NOT EXPOSE THE INVERTER TO RAIN, SNOW, SPRAY, BILGE OR
DUST. DOING SO MAY RESULT IN DAMAGE TO THE INVERTER OR OTHER APPLIANCES INSTALLED
IN THE SYSTEM OR RESULT IN ELECTRIC SHOCK OR FIRE.
3. RISK OF ELECTRICAL SHOCK. OPERATION OF THE INVERTER WITHOUT A PROPER GROUND
CONNECTION MAY RESULT IN AN ELECTRICAL SAFETY HAZARD. ENSURE PROPER GROUND
CONNECTION IS MADE DURING INSTALLATION. FOR FIXED AND/OR TRANSPORTABLE (VEHICLE)
INSTALLATIONS, INSTALL ACCORDING TO APPROPRIATE AS/NZS STANDARD.
4. RISK OF ELECTRICAL SHOCK. BEFORE PROCEEDING, CAREFULLY CHECK THAT THE INVERTER
IS NOT CONNECTED TO ANY BATTERIES AND THAT ALL WIRING IS DISCONNECTED FROM ANY
ELECTRICAL SOURCES.
5. DO NOT CONNECT THE OUTPUT TERMINALS OF THE INVERTER TO AN INCOMING AC SOURCE.
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they are supervised or have been
instructed on how to use the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
2. Do not operate the inverter with damaged or substandard wiring. Selecting the wrong cable or fuse
size could result in harm to the installer or user and/or damage to the inverter or other appliances
installed in the system. The installer is responsible for ensuring that the correct cable and fuse sizes
are used when installing this inverter. Refer to section 2.2.4 for more information.
3. Ensure that all the DC connections are tight - torque to 2.8 Nm (1.5 ft-lbs). Loose connections could
result in overheating and can be a potential hazard.
4. Some components in the inverter can cause arcs and sparks. Do not put batteries, flammable
materials, or anything that should be ignition–protected around the inverter. Doing so may result in fire
or explosion.
SAL.FOR.Instruction Manual.350RS Inverters - DOC1100 – Version 7
To Next Page
Loading...
Need help?
General
