seconds then the gear motor’s driver will be cut off
immediately and show the E1 on the LCD display. All the
other digital and function mark are blank, and the output
signals are cut off also.
E2 (ERROR 2): When the monitor read the memory data, if the I.D. code is not correct or
the memory IC damages then the monitor will show E2 immediately at
power on.
E3 (ERROR 3): After 4 seconds by start mode, the computer detects the faulty motor did
not leave the zero point then the LCD bar displays “E3”.
LCD Workout Graphics
PRESET PROGRAM PROFILES:
PROGRAM 1 PROGRAM 2 PROGRAM 3
MANUAL ROLLING VALLEY
PROGRAM 4 PROGRAM 5 PROGRAM 6
FAT BURN RAMP . MOUNTAIN
To Next Page
Loading...
