REED 5A - Page 5

Figure 10
o) Set tonearm lever [9c] on the tonearm
front link [8] so that the lever bearing
needle [9d] would be embed in sapphire V
cup of the tonearm front link [8] (Figure
10).
Figure 11
p) Check if the tonearm lever bearing [9d] is
in correct position. Needle of the bearing
must be embedded in sapphire V cup.
Check if the armwand can move freely.
Fasten armwand [7] using fastening screw
[6a] (Figure 11).
7
8