Need help?Do you have a question about the REED 5A and is the answer not in the manual?
General| Brand | REED |
|---|---|
| Model | 5A |
| Category | Measuring Instruments |
| Language | English |
Mark three holes on the turntable for the tonearm base using the template.
Drill 4.2 mm holes and thread them with M5 thread.
Attach a cartridge, check position with protractor, and handle wiring carefully.
Adjust VTF by setting tonearm balance and counterweight position.
Adjust armwand height to be parallel to the record.
Adjust horizontality screws until the level bubble is centered.
Adjust the armtube azimuth by turning it and tightening the screw.
Check tonearm alignment using a protractor and template.
To Next Page
