36
6. Preparations
a) Delivery scope
• Chassis CF-6DT with installed two-stroke engine with cable pull starter and tuning sound absorber
• Imprinted body with attached decal sheet
• Mounted steering servo, throttle/brake servo and receiver
• Three-channel radio remote control (pistol transmitter)
• Installed air filter
• Installed spark plug
• Aerial tube for receiver aerial
• Telescope antenna for transmitter
• Small parts
• Operating instructions for the vehicle
• Operating instructions for remote control system
b) Required accessories (not part of the delivery)
• 8 rechargeable or normal batteries (mignon type AA) for the transmitter
• 6 V hump rechargeable battery pack for the receiver
• Charger for the hump battery pack
• Spark plug wrench
• Tank bottle
• Air filter oil
• Two-stroke mix 1:25 oil/fuel with super or super plus fuel
• Body drill and body shears
c) Replacement parts
The spare part list can be found on our website www.conrad.com in the download section for the respective product.
Alternatively, you may also call to request the list of spare parts. For contact information, see "Introduction" at the beginning of these operating
instructions.
d) Recommended accessories, General Information
Which type of fuel is the right one?
Only use regular two-stroke mix on the basis of super or super plus fuel and 4% oil (ratio 25:1)! A mixture with a smaller oil proportion (too little lubrication) causes
the engine to overheat and causes serious damages.
Loss of guarantee/warranty!
Why is a tank bottle needed?
Filling the tank is made much easier by using the small, special tank bottle with a thin, bent pipe. This prevents spilling the fuel.
Spilled fuel not only damages the environment but also poses a fire and explosion risk!
Are more spark plugs necessary?
Spark plugs wear, especially in the running-in phase. Thus, we recommend to always keep in store some spark plugs for replacement.
Only use the recommended spark plugs of the type CMR 7H! A wrong spark plug lets the engine run faulty and makes tuning more difficult.
Occasionally check the body structure and the contact clearance of the spark plug!
Installation/exchange of spark plugs
Requires a spark plug wrench (four-way socket wrench SW10).
To Next Page
Loading...
