VOLVO SX PROPELLER INSTALLATION CON’T
4. Slide propeller on sha completely.
5. Place thrust washer on propeller sha splines.
6. With the key switch in the o position remove the keys from the
ignition. Now shi the remote control into reverse
7. Install and tighten the propeller nut to the engine manufacturer’s
speci cations using a torque wrench.
8. If used place keeper on prop nut until aligned with cotter key
hole. Install cotter key and bend tabs over.
1) rust Bushing
2) Propeller
3) rust Washer
4) Propeller Nut
5) Keeper (If used)
6) Cotter Key
Typical Volvo SX Installation
To Next Page
Loading...
