e typical bucket seat slider assembly needs
periodic inspection and maintenance. Loosen
the tension knob located on the slider and pull
up to separate the slider from the pedestal. In
some cases, you may need to pull up on the
swivel handle to release spring tension while
pulling up on the slider assembly. Inspect all
fasteners and metal for fatigue. Lubricate the top/outside of the
pedestal as needed with a marine type grease that will not run o
under warm temperatures. A narrow paint brush is a way to apply
the grease. Also, use silicone spray for areas that can not be accessed
with the grease. Check for loose fasteners and tighten as necessary.
Reassemble slider to pedestal and tighten tension knob.
SEATING-BUCKET SEAT SLIDER ASSY.
Swivel Handle
Tension Knob
Seat
Seat Slider
Pedestal
To Next Page
Loading...
