Form: 640188 TS-11
Defective or improperly
installed VCP to Control
Head Cable (510575).
Check cable connections at the rear
of the Control Head (700227), and at
the rear of the VCP. If possible
perform a continuity test on the
cable. Repair or replace cable as
necessary.
Defective Control Head
(700227).
Activate the Video System. Operate
the VCP directly from its front panel
controls. If unit functions correctly,
and the VCP to Control Head Cable
(510575) has been checked, Repair
or replace the Control Head
(700227).
Defective VCP (models may
vary).
It may be difficult to determine if
problem originates in the VCP or the
Control Head. If VCP cannot be
operated directly from its front panel
controls, or replacing the Control
Head does not correct the problem,
repair or replace the VCP.
As some system configurations may vary, depending on the exact equipment and/or
options that have been installed, please contact Radio Engineering Ind. directly
(1-800-228-9275) if there are any further questions or problems that might arise.
To Next Page
Loading...
