3. Fasten the scooter standpipe and fold
out the kickstand.
6. After the installation is complete, switch
the scooter on and off to check that the scooter
is working properly.
2. Hold the scooter upright, to ensure that the lock will not be affected, please keep the folding-
spanner.
(the blue part of the image) at the bottom. Pull the folding-spanner to the top, then the scooter is
completely locked.
4. Install the handlebar to the standpipe.
5. Use the hex wrench in the tool bag to
lock the screws on both sides.
9 10
BUILD ME
To Next Page
Loading...
