What to do if the REMEHA Calenta 35s flow temperature sensor is short circuited?
If the flow temperature sensor of your REMEHA Boiler is short circuited, it could be due to several reasons. First, check the wiring for any bad connections. Then, verify that the sensors are operating correctly and that the sensor has been correctly fitted. If these steps don't resolve the issue, consider replacing the sensor.
What to do if the REMEHA Boiler safety parameters are incorrect?
If the safety parameters for your REMEHA Boiler are incorrect, it might be due to a bad connection. In this case, check the wiring. Alternatively, the PSU could be defective, so consider replacing it.
What to do if the REMEHA Calenta 35s flow temperature sensor has an open circuit?
If the flow temperature sensor of your REMEHA Boiler has an open circuit, first check the wiring for any bad connections. Also, check that the sensors are operating correctly and that the sensor has been correctly fitted. If the problem persists, replace the sensor.
How to fix REMEHA Boiler storage unit PSU parameter not found?
If the storage unit PSU parameter is not found in your REMEHA Boiler, the problem could be a bad connection. Check the wiring to resolve this issue.
Crucial safety warnings and procedures for gas and flue gas.
Legal and standard requirements for boiler installation.
Instructions for connecting water circuits.
Instructions for connecting the gas supply.
Instructions for connecting flue and air intake.
Instructions for wiring the boiler.
Essential checks to perform before boiler startup.
Procedures for initial boiler operation and setup.
Instructions for setting gas type and air/gas ratio.
Routine checks and servicing procedures.
Identifying and resolving boiler faults using error codes.
To Next Page
General