What to do if the REMEHA Boiler flow temperature sensor is short circuited?
If the flow temperature sensor of your REMEHA Boiler is short circuited, it could be due to several reasons. First, check the wiring for any bad connections. Then, verify that the sensors are operating correctly and that the sensor has been correctly fitted. If these steps don't resolve the issue, consider replacing the sensor.
What to do if the REMEHA Boiler safety parameters are incorrect?
If the safety parameters for your REMEHA Boiler are incorrect, it might be due to a bad connection. In this case, check the wiring. Alternatively, the PSU could be defective, so consider replacing it.
What to do if the REMEHA Boiler flow temperature sensor has an open circuit?
If the flow temperature sensor of your REMEHA Boiler has an open circuit, first check the wiring for any bad connections. Also, check that the sensors are operating correctly and that the sensor has been correctly fitted. If the problem persists, replace the sensor.
How to fix REMEHA Calenta 40c Boiler storage unit PSU parameter not found?
If the storage unit PSU parameter is not found in your REMEHA Boiler, the problem could be a bad connection. Check the wiring to resolve this issue.
General| Output | 40 kW |
|---|---|
| Fuel Type | Natural Gas |
| Mounting | Wall-mounted |
| Max. DHW output | 40 kW |
| Water pressure | 1 - 3 bar |
Critical safety advice for gas and flue gas leaks.
Warnings for installation, maintenance, and environmental conditions.
Outlines mandatory regulations and standards for boiler installation.
Covers choosing location, mounting, ventilation, and physical dimensions.
Details classifications, outlets, pipe lengths, and specific pipe connections.
Guide to connecting controls, sensors, optional PCBs, and wiring diagrams.
Step-by-step guide for initial boiler start-up and operation.
Covers gas type adaptation and setting air/gas ratios for different loads.
Lists and explains error codes, their causes, and solutions.
Explains blocking modes, lock-outs, and how to read codes.
To Next Page