12
15. LOCKOUT MODE / TAMPER PROTECTION
16. INTERIOR LIGHTING
8
#
1 2 3 4
5
6 7
*
9
0
Red & Green = Low Baery
14. LOW BATTERY ALERT
1.
Three consecutive rejected security code entries
puts the safe in “Basic Lockout” mode. The touch
pad is deactivated for 30 seconds.
2.
Six consecutive rejected security code entries
results in “Severe Lockout” mode. The touch pad is
deactivated for 5 minutes.
Note: During lockout mode, the yellow lock LED will light
up once every 10 seconds. When lockout mode has ended,
the green unlock LED will flash 1 time and you will hear
1 beep to signify the lockout mode has ended. You will
now have access to your touch pad.
3. After the safe enters basic or severe lockout mode, the tamper indicator will trigger
to warn you that someone has unsuccessfully attempted to gain access to your safe.
This tamper indicator will signal immediately after the next successful code is
entered. The yellow lock LED will flash 3 times and in addition to a 3 second long
beep.
This lock face is equipped to alert you when the
batteries are low by illuminating the red light
(center) when any button is pressed on the
keypad. Please replace batteries immediately
when receiving this warning.
Always test the batteries when installing or
replacing. If the red light comes on when a
button is pressed you know the batteries are not
fully charged.
This safe comes with proximity based interior lighting installed. When the USB
powered internal lighting is plugged into the USB power source, the lighting will
function automatically when the door is open.
To Next Page
Loading...