6
4.
3.
Using a dolly capable of supporting the size and weight of your safe, move the safe
to your desired location. Please take all necessary precautions to protect and prevent
any damage to your flooring.
HELPFUL: TO DETERMINE WHETHER YOUR SAFE WILL MAKE IT THROUGH
DOORWAYS, STAIRS, OR CORNERS, TAKE THE EMPTY SAFE BOX AND SEE IF IT
WILL FIT ALL THE WAY THROUGH TO ITS FINAL LOCATION.
5.
6.
7.
The safe should be installed adjacent to a side wall with minimal space on either
side of the safe. Wherever possible, the safe should be flat against the wall and
floor. Remove the baseboard and/or wall trim if necessary.
Always ensure the safe is in an isolated and dry area. Never place the safe in direct
contact with a wet floor. When installing your safe on a concrete floor, use of a
moisture/protective barrier is highly recommended. Failure to do so, or exposing
the safe to chemicals or other adverse environments, may void the warranty.
If your safe seems unlevel, you may need to shim the bottom of the safe to
prevent the door from swinging open too quickly, or closing on itself.
1.
2.
WARNING: SAFES ARE VERY HEAVY AND AWKWARD TO HANDLE. PLEASE USE THE
UTMOST CARE IN MOVING THE SAFE. UTILIZING A TRAINED PROFESSIONAL WITH
PROPER MOVING EQUIPMENT IS HIGHLY RECOMMENDED.
The location of the executive safe is very important and the utmost care should be
taken during this consideration.
To maximize the fire protection of your safe, we recommend you place the safe in
lower levels in your home where fire temperatures are lower and away from highly
combustible materials.
To maximize burglary protection and stability, securing the safe to the floor
is recommended.
SA Consumer Products recommends that you store your safe in a closet, office,
basement, bedroom or any other location that is convenient for you but out of
direct line of sight from prying eyes. The location of the safe is very important.
SA Consumer Products requires the safe is secured to the floor to ensure safe
does not tip over in case of a flood.
6. PROPER PLACEMENT AND MOVING OF SAFE
We recommend placing a moisture/protective barrier between your safe and
concrete floor to prevent any moisture, mildew and rust damage to the safe.
Installing your safe in a place with climate control (heat in the winter and cooling
in the summer) is highly recommended. In areas of high humidity or frequent
temperature fluctuations (garages) it is recommended to take appropriate
precautions to ward against moisture damage. We strongly encourage the use of
an internal dehumidifier and/or desiccants to protect your contents from rust or
mildew. Internal dehumidifiers should not be in direct contact with the side or
back walls.
7. KEEPING YOUR SAFE DRY
To Next Page
Loading...