Need help?Do you have a question about the REMIS REMIcare Van and is the answer not in the manual?
General| Brand | REMIS |
|---|---|
| Model | REMIcare Van |
| Category | Automobile Accessories |
| Language | English |
Verify all supplied parts for the insect protection door installation, including coffer, shutter, and fixation components.
Install fixation brackets, frame corners, brush, and guide the string according to provided images and instructions.
Mount the shutter into the coffer notch and fix with tape; attach the floor rail to the tread, ensuring end cap contact.
Position the door in the frame, ensuring the shutter is between the rubber joint and kitchen furniture. Two people recommended.
Place the coffer in the marked area, ensuring the shutter stays in place and the floor rail rests on the floor cover.
Carefully guide the top guiding rail past the door sealing into the interior.
Screw the floor rail tightly using the 2.9x16 countersunk bolt (A).
Close the door, mark the top guiding profile's end cap position, ensuring parallel alignment with the door sealing.
Return the door to idle position and screw the top guiding rail using the 3.5x16mm panhead bolt (B).
Secure the fixation bracket to furniture, adjusting height by loosening and retightening the panhead bolt (C).
Use Allen screw to adjust the string stretcher, either towards the handle bar to tighten or opposite to loosen. Tighten grub screw.
Ensure the handle bar runs parallel to the coffer profile or door sealing. Note on stretching/loosening directions.
To Next Page
