ZXT-800 AC/AV MASTER USER MANUAL
3. Get Started
User Guide × 1
ZXT-800 × 1
3.1 Step-1 Apply Power to ZXT-800
• 3 × AAA batteries or Micro USB
• ZXT-800 will detect the rst applied power source to decide what Z-Wave device role
it will be in after included into the Z-Wave gateway:
– Battery = sleeping device (FLiRS mode)
– USB power = always awake device (Always Listening mode)
Please refer to Z-Wave Glossary for more information.
• Once the ZXT-800 is included into a Z-Wave network, the working mode (sleeping or
awake) cannot be changed, unless it is excluded and re-apply the power.
• ZXT-800 can be included and operated in any Z-Wave network with other Z-Wave certi-
ed devices from other manufacturers and/or other applications. All non-battery oper-
ating nodes within the network will act as repeaters regardless of Vendor to increase
reliability of the network.
Caution
• Use new batteries of the recommended type and size only.
• Never mix used and new batteries together.
• To avoid chemical leaks, remove batteries from the ZXT-800 if you do not intend to use
the device for an extended period of time.
• Dispose of used batteries properly; Do not burn or bury them.
CONTENTS [ 4 | 23 ]
To Next Page
Loading...
