EasyManua.ls Logo

Renault ALASKAN 2017 - Page 74

Renault ALASKAN 2017
340 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE
The Settings menu cannot be operated while
driving.
[Driver Assistance]
Use the
or switches and the <ENTER> button
to change the status, or turn on or off any of the sys-
tems displayed in the [Driver Assistance] menu. The
following menu options are available:
[Driving Aids] (where fitted):
The [Driving Aids] option has asub-menu, from
which you can choose whether to turn ON or OFF
the following item:
[Emergency Brake]
Select this item to enable/disable the Active
Emergency Braking system. For additional infor-
mation see, “Active Emergency Braking system
(where fitted)” in the “5. Starting and driving”
section.
[Parking Aids] (where fitted):
The [Parking Aids] option has asub-menu, from
which you can choose the following:
[Sensor]
Select this item to enable/disable the parking
sensor (sonar).
[Volume]
Select this sub-menu to change the parking sen-
sor (sonar) buzzer volume to one of the follow-
ing:
–[High]
Loudest available volume.
–[Med.]
Medium volume. (Standard)
–[Low]
Lowest available volume.
[Range]
Select this sub-menu to change the parking sen-
sor (sonar) detection range to one of the follow-
ing:
–[Far]
The parking sensor system will give earlier
notice of objects further away.
–[Mid.]
The parking sensor system is set to the stan-
dard distance.
–[Near]
The parking sensor system will only give no-
tice of objects close by.
[Clock]
The following sub-menus are available in the clock
menu, depending on the level of equipment of each
vehicle.
[Set the Clock in NAVI] (where fitted)
The clock needs to be adjusted in the navigation
system and will automatically be synchronised.
See the separately provided Navigation Owner’s
Manual.
[Set the Clock in Audio] (where fitted)
The clock needs to be adjusted in the audio sys-
tem and will automatically be synchronised.
See “Setting the clock” in the “4. Display screen,
heater and air conditioner, and audio system”
section, or “How to use <SETUP> button” in the
“4. Display screen, heater and air conditioner,
and audio system” section.
[Set Clock] (where fitted)
Select this sub-menu to adjust the time on the
clock.
[12Hr/24Hr] (where fitted)
Select this sub-menu to choose the clock format
between 12-hour and 24-hour.
2-16 Instruments and controls

Table of Contents