Renault Avantime 2002 - On-Board Computer

G
2
QXBIUDB*T[G3DJH
AVANTIME D66 nu647-2
C:\Documentum\Checkout\nu647-2_eng_T1.WIN 3/4/2002 13:01
-page52
1.46
ON-BOARD COMPUTER
1-DisplayG
2 - Reset button
- press and hold button 2
Zeroing will occur automatically
when the maximum capacity of any
of the memories is exceeded.
2 - Display selection button:
Press key 2 briefly and successively
to display the following
information:
- Distance travelled.
- Average speed.
- Average fuel consumption.
- Current fuel consumption.
- Estimated range.
- Recommended speed (speed
limiter/cruise control),
- Range.
Interpreting certain values
displayed after a reset:
The values showing average fuel
consumption, range and average
speedwillbecomemorestableand
reliable the further you travel since
the last time the reset key was
pressed.
For the first few miles after pressing
the reset key you will notice:
• that the range increases as you
travel. This is normal. Average
fuel consumption may decrease
when:
- The car stops accelerating.
- The engine reaches its operating
temperature.
- When you drive from a built up
area on to the open road.
Therefore, if the average fuel
consumption decreases, the range
will increase.
• The average fuel consumption
increases when the vehicle is
stationary with the engine idling.
This is normal since the module
takes account of fuel used during
idling.