ADDITIONAL DRIVING AID FUNCTIONS
3
200 - Driving
Ensure that zone
C
around the radars
on each side of the rear bumper are
not obstructed (by dirt, mud, snow,
etc.).
If one of the radars is obscured, the
"Side radars without visibility" message
is displayed on the instrument panel.
Clean the area where the sensors are
located.
Warning light 2
A warning light
2
is located on each
door mirror
3
.
Note:
– clean the
3
rear view mirrors
regularly, so that the indicator lights
2
can be seen properly;
– if you overtake another vehicle, the
warning light
2
will only come on, if
that vehicle remains for a long enough
period in your vehicle's blind spot area
A
.
Display D
First warning: direction indicator not
activated, the warning light
2
indicates that a vehicle is detected in
the blind spot area and/or that a
vehicle is rapidly approaching from the
rear in an adjacent lane.
Display E
Direction indicator activated, the
2
warning light flashes when the function
detects a vehicle in the blind spot
warning area and/or a vehicle is
rapidly approaching from the rear on
the side towards which you will turn
the wheel. If you cancel the direction
indicator, the function will return to the
initial warning (display
D
).
Conditions for non-function
– When driving on a road with tight
bends;
– in reverse.
If the vehicle is equipped with a towbar
recognised by the system, the "Trailer:
blind spot warning off" message is
displayed on the instrument panel to
inform you that the function is not
operational. For information on the
range of equipment adapted to your
vehicle, we advise you to consult an
approved Dealer.
Operating faults
If the system detects a fault, the
"Check Side radars" message is
displayed on the instrument panel.
Consult an approved dealer.
To Next Page