A
B
C
NU747_1_G5-FRA.qxd 12/01/05 14:51 Page 5.20
BC85 - NU747-1
C:\Documentum\Checkout\NU747_1_T5-ENG.win 3/3/2005 11:57
-page20
5.20
BATTERY: breakdown
To avoid all risk of sparks:
-Makesurethe“electrical
consumers” are switched off
before disconnecting or
reconnecting the battery.
- When charging, stop the charger
before connecting or
disconnecting the battery.
- Do not place metal objects on the
battery to avoid creating a short
circuit between the terminals.
- Never disconnect a battery less
than twenty seconds after the
engine has been switched off.
- Make sure that you reconnect the
battery terminals after refitting.
Access to the battery
Depending on the vehicle, unclip
then pull unit A in the engine
compartment.
Unclip cover B then remove it. Then
unclip cover C and remove it.
Refitting the battery covers
- position cover C in its hinges and
clip it in place,
- then position cover B in its hinges
and clip it in place,
Make sure that both covers B and C
are fastened correctly.
Depending on the vehicle,
reposition unit A, by tilting it
forwards, and clip it by tilting it
backwards. Check that it is properly
secured
Handle the battery with care as it contains sulphuric acid which
must not come into contact with the eyes or skin. If it does, wash
the affected area with plenty of cold water.
Ensure that naked flames, red-hot objects and sparks do not come
into contact with the battery as there is a risk of explosion.
Take care when working in the engine compartment as the engine cooling
fan may start to operate at any moment without warning.
To Next Page
Loading...
